Players obviously bring their equipment with them to events, and this equipment values to lots of moola. Unfortunately, some people are douchebags and decide to steal your shit and sell it. Well, APPA has a solution for this situation and that is players are now able to bring their gearbag to the registration tent and pay a $10 fee for them to secure all your gear so you have more time to play around at the event without having to worry about your gear being unattended. There will also be an option to have your stuff locked up overnight, so you don’t even have to bother hauling all your gear to and from the hotel. Gear-sitting will begin at the 2008 Chicago PSP Open.
Starting at the 2008 Chicago PSP Open, there will now be a semi-pro class for players. This is a classification not a division. This was basically done because the NXL was reduced down to 12 teams from 16. By doing this, PSP has given no name, teamless pros a chance to play and prevent sand-bagging.
I thought it was official before, but not according to Keely.
It’s actually one ball every 75 milliseconds, which does translate into 13 1/3 BPS (75 * 40 / 3 = 25 * 40 = 1000 ~ 1), but it’s actually too fast for 13.33 BPS (75 * 13.33 = 999.75 < 1000 therefore, it's too fast). But that assumes that all the shots are consistent, which there are often possibilities where that isn't the case. The PSP rules also state that only a maximum of 3 shots per trigger pull can be fired. Here's the time over 1 pull if the firing is consistent: pull = fire + 75 ms + fire + 75 ms + fire + 75 ms = 225 ms (assuming the time firing takes is consistent and negligible) Another case, let's say a ball takes a bit to load, say an extra 20 ms (don't argue, my loader is super fast, so that's not going to happen, whatever, shit happens): pull = fire + 75 ms + 20 ms (slow ball loading) + fire + 75 ms + fire + 75 ms = 245 ms (assuming the same as above) You just got jipped out of 20 ms. For that time period,you just shot ~12.24 BPS. Let's say the same thing happens, but the board software is able to compensate for those few milliseconds (it's totally feasible for the software to be able to do this): pull = fire + 75 ms + 20 ms (slow ball loading) + fire + 55 ms + fire + 75 ms = 225 ms (same assumptions) Now, you just shot 13 1/3 (about 13.33) BPS, which is what the general rules state, but you would actually receive a gross penalty for more than one shot in a 65 ms time span. So, the rules are actually, you may shoot 1 ball every 75 ms, not 13.33 BPS.
Also, in order to truly determine if the rate of fire is 13.33 or under (actually, 13 1/3) is to measure the gun over a 3 second time span (1/3 shots take some work to measure) and see if it shoots 40 shots or less over that time period with at least 14 (or 13) trigger pulls (13 1/3 pulls technically. If it the measurement didn’t start exactly when the first trigger pull occurred but after it but the first shot was counted as time 0, it could be done in 13 since the shot(s) from the previous trigger pull would run into the time period i.e. the 1 shot from the previous trigger pull plus the 39 from the subsequent 13 pulls). Now, of course, they aren’t going to measure it that way, since it’s a waste of paint and time, and probably seems a tad complicated. They’re going to measure it using a simplistic representation of it, as in, you need 75 ms between shots, because it’s easier and can represent 13.33 BPS (really, 13 1/3), but it’s not always true, as shown in the case above.
Am I saying their 75 ms between shots is bad? No, I’m just saying that saying it’s not 13.33 BPS (again, 13 1/3). It can be, but it’s not always. The rules should only state the 75 ms rule, not 13.33 BPS.
As a side note, I’m wondering how boards calculate their shots.
Does it use multi-threading, like a thread for each function (trigger monitoring, eye monitoring, rate of fire, etc.) or is it more of a when an event occurs, check the sensors then fire. I think I’m going to write a python script to demonstrate this.
Wrote previous mentioned python scripts, get them here, http://nothingoutoftheordinary.com/2008/01/10/paintball-board-software-types/
We’ll be playing in soccer fields next to it.
Anyways, in their press release, they go into detail about how the University of Phoenix stadium is the best stadium evar!!11! Then goes into to say whats around there, like an AMC, because those are so rare. It’s not like I have 2 within 5 miles of me; I would just have to chose to turn left or right, though I actually I go to the Cinemark that’s even closer.
There’s also the Jobing.com (really, jobing.com) Arena just down the street. They’ll be hosting some Pepsi concert thing on Super Bowl weekend (that’s in January/Feburary). How cool. But during the tournament, you can see the Coyotes vs the Canucks or the Oilers. I’m sure those will be great games, since Arizona is such a birth place for great hockey players. They’re currently 6-10-1 at home.
If that doesn’t have you won over, too bad. There aren’t anymore reasons to go. Sorry. I think some paintball tournament might be happening there, but I didn’t really read anything about that though.